Answers are grounded in this paper and cite their sources.
This study experimentally evaluated front-surface water-film cooling and rear-mounted aluminum heat sinks for polycrystalline photovoltaic modules under outdoor conditions. Two 100-Wp modules of the same model were monitored from November 2025 to March 2026, with temperature, voltage, and current recorded at 1-min intervals. During the representative active test, the maximum backsheet temperature was 42.0 °C for the water-film configuration and 50.5 °C for the reference module, a difference of 8.5 °C. Across nine monitoring days, differences between their daily maximum temperatures ranged from 8.5 °C to 18.96 °C. After subtracting 22.89 Wh of pump consumption, excluding power-supply losses and control-system consumption, the active configuration delivered 475.05 Wh of net electrical energy, compared with 438.06 Wh for the reference, corresponding to a difference of 8.44%. During the representative passive test, the heat-sink configuration showed a maximum backsheet temperature 1.50 °C below the reference and a daily electrical-energy difference of 1.70%, smaller than its reported expanded uncertainty. The investigated module operated with maximum power point tracking, while the reference used a fixed resistive load. Consequently, the electrical differences reflect both cooling and electrical load management and cannot be attributed exclusively to cooling. The water-film configuration showed a larger temperature reduction under its test conditions, but the active and passive results were obtained on different days and do not establish a comparison under matched environmental conditions.
No takes yet. Share an insight, caveat, or question.
Martins et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: