Answers are grounded in this paper and cite their sources.
This study investigates the drilling performance of glass‐steel‐epoxy hybrid composites with two stacking configurations, G7S4 and G4S7, using a Taguchi L 25 design. The effects of spindle speed (1000–3000 rpm), feed rate (20–100 mm/min), and drill diameter (2–10 mm) on thrust force, torque, and exit‐side delamination factor are investigated. Analysis of variance revealed that drill diameter is the dominant parameter affecting thrust force, contributing 63.49% and 60.93% for G7S4 and G4S7, respectively, while its contribution to torque is 66.37% and 68.06%. In contrast, feed rate is the most influential parameter governing delamination, contributing 71.44% for G7S4 and 69.58% for G4S7. For the combined drilling responses, feed rate showed the highest influence, with contributions of 58.94% and 59.40% for G7S4 and G4S7, respectively, followed by drill diameter. Grey relational analysis identified optimum experimental combinations of 1500 rpm, 20 mm/min, and 4 mm for G7S4 and 2000 rpm, 20 mm/min, and 6 mm for G4S7. The findings of this study suggest that by increasing the steel reinforced layers, improved results such as reduced exit‐side delamination are obtained, highlighting the influence of hybrid stacking architecture on drilling performance.
No takes yet. Share an insight, caveat, or question.
Bhoi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: