Answers are grounded in this paper and cite their sources.
Conventional yarn abrasion testing determines the number of abrasion cycles to break but does not reveal the changes in yarn geometry that occur before failure. The aim of this study was to apply and evaluate a longitudinal image-based method for monitoring changes in yarn-body diameter during progressive abrasion. Eight yarns differing in linear density and construction were investigated in untreated, conventionally sized, and pre-wetted sizing conditions. Abrasion resistance was determined using a Zweigle G551 abrasion tester, with 20 specimens tested per yarn–treatment combination. Five of these specimens were monitored longitudinally by digital microscopy at predefined abrasion intervals until breakage or the final observation. Yarn diameter was determined using Fiji (ImageJ) and the Ridge Detection plugin. A supplementary methodological evaluation showed maximum deviations of 0.40–1.22% in a parameter-sensitivity assessment and differences of −1.35% to +2.50% between automated and manual measurements on representative images. Conventional sizing yielded the highest geometric mean cycles to break for all eight yarns, although statistically significant treatment effects were detected for six yarns. Longitudinal diameter changes varied among specimens and abrasion stages, with some yarns showing an initial decrease followed by stabilization or an increase. The results demonstrate the potential of repeated image-based measurements to complement conventional abrasion testing by characterizing changes in yarn geometry before failure. Further validation of image registration and measurement repeatability is required.
No takes yet. Share an insight, caveat, or question.
Kalazić et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: