Answers are grounded in this paper and cite their sources.
Polycrystalline diamond compact (PDC) bits are the mainstream rock-breaking tools in oil and gas drilling, yet their cutters are highly susceptible to premature failure under the high-temperature, high-pressure, and heterogeneous formations encountered in deep wells. The chamfer angle directly governs the sharpness and chipping resistance of the cutting edge; however, the influence of large chamfer angles on cutter performance remains poorly understood. To address this, we fabricated 1613-specification PDC cutters and machined them by laser engraving into four chamfer geometries—15°, 20°, 25°, and a two-stage 15°+30° chamfer—and systematically evaluated their impact toughness, wear resistance, thermal stability, and residual stress through drop-weight impact, vertical-lathe turning, thermal expansion, and Raman spectroscopy. The results show that the impact resistance of the cutters improves markedly with increasing chamfer angle, reaching up to approximately 64% above the standard product, whereas the wear resistance deteriorates correspondingly; the chamfer exerts no obvious effect on the thermal stability. Raman analysis reveals that laser engraving converts the cutting-edge region from residual tensile stress (approximately +0.8 to +1.3 GPa) into compressive stress (approximately -1.9 to -2.1 GPa), which suppresses crack initiation and propagation. This work provides a practical basis for the selection of large chamfer angles and the structural optimization of PDC cutters for drilling.
No takes yet. Share an insight, caveat, or question.
Xue et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: