Answers are grounded in this paper and cite their sources.
This study investigates the temperature-dependent creep response of epoxy-bonded aluminum single-lap joints (SLJs), with a particular focus on joint behavior as the service temperature approaches the adhesive glass transition temperature (Tg). Tensile and creep tests were conducted on both bulk adhesive specimens and SLJs at 20, 40, and 60 °C. The results show a significant degradation in mechanical properties with increasing temperature. The adhesive Young’s modulus near Tg decreases by more than one order of magnitude compared to room temperature, while the strength and toughness are reduced by over 65% and 75%, respectively. Creep deformation is strongly accelerated at elevated temperatures, with substantial increases in strain and an earlier onset of tertiary creep. These effects translate directly to joint behavior, with SLJs exhibiting up to a 64% reduction in ultimate load and an increase in compliance. A temperature- and stress-dependent power-law creep model was calibrated using true stress-true strain data over a wide range of loading levels (12-62% of ultimate strength). The model was implemented in finite element simulations, which show good agreement with the experimental results and provide insight into stress redistribution and relaxation within the adhesive layer. Time-temperature superposition (TTS) was also applied to evaluate long-term creep behavior. The resulting master curves indicate that, within the stable creep regime, temperature primarily acts as a time-scaling factor, enabling extrapolation of creep deformation beyond the experimental time range.
No takes yet. Share an insight, caveat, or question.
Khabaz‐Aghdam et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: