Answers are grounded in this paper and cite their sources.
Mg alloy microtubes for bioresorbable vascular stents require dimensional accuracy, adequate room-temperature tensile properties, and predictable degradation behavior. In this study, Mg–1.07Zn–0.49Mn–0.52Sr (wt%) alloy microtubes were fabricated by two-step direct extrusion without (NC) and with die-exit argon-gas cooling (AGC). Both conditions produced microtubes with an outer diameter of approximately 2.1 mm and a wall thickness close to 0.20 mm. AGC modified the monitored subsurface near-exit die-temperature history, but the measurements neither quantified microtube cooling rates nor isolated post-exit cooling. Across three EBSD maps of the same specimen per condition, AGC reduced the mean area-weighted grain diameter from 9.2 ± 0.2 µm to 5.1 ± 0.1 µm (mean ± SD of map-level values), a reduction of approximately 44%. The area fraction of high grain orientation spread (GOS ≥ 1°) increased from 4.7 ± 2.1% to 10.0 ± 0.8%. Both conditions retained a dominant extrusion-related texture, with similar mean Schmid factors for basal and prismatic 〈a〉 slip. AGC increased the tensile yield strength from 197 ± 1 MPa to 227 ± 1 MPa and the ultimate tensile strength from 243 ± 3 MPa to 265 ± 1 MPa. Elongation was 8.7 ± 1.2% for NC and 8.5 ± 0.8% for AGC; ductility equivalence was not established with three specimens per condition. Work-hardening analysis using effective true stress suggested a higher initial flow stress in AGC without enhanced post-yield hardening. Seven-day hydrogen-evolution and mass-loss measurements did not resolve a difference between NC and AGC (n = 3 per condition), and the electrochemical responses showed no persistent separation. AGC was associated with a finer as-extruded microstructure and higher axial tensile strength, while the short-term degradation behavior did not establish equivalence between conditions.
No takes yet. Share an insight, caveat, or question.
Suh et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: