Answers are grounded in this paper and cite their sources.
A compact, high-temperature tube furnace capable of 1 800°C continuous operation was designed for novel alloy development and integrated within a small-scale gas atomizer. Off-the-shelf components minimized machining and enabled construction for less than ~$8 000. A hollow carbon arc gouging electrode acting as the furnace tube was heated by an axial current flow. Reaction rates between the carbon tube body and the Cu-Ti, Cr alloys occurr at much longer timescales than the 6-min alloy melt time, mitigating reactions with metal alloys.Water-cooled end-cap electrodes on opposing ends of a 2.75-deg ConFlat cross and forced air cool the furnace envelope. PAN (polyacrylonitrile) graphite felt insulation within the furnace envelope reduced radiative heat loss, while an argon gas purge preventeds oxidation. The low-cost carbon tube enabled replacement between runs to eliminate material cross contamination.A PID (proportional-integral-derivative) feedback control stabilized the carbon tube temperature, which was measured by a two-color pyrometer within a steady-state error of <0.5°C and achieved a rise time to 1 800°C of under 20 s. Intermittent operation at 2 360°C with 1 810 W of heating power was limited by the degradation of the Viton O-rings and the pyrometer measurement range.Axial thermocouple measurements indicated an 80-mm-long section of uniform temperature. A pulsed argon feed ejected the molten alloy melt from the furnace into the associated gas atomizer. Scanning electron microscopy/energy dispersive Xr-ay analyses of the powders from test melts indicated a consistent distribution of the solute elements within the individual gas-atomized powder particles for the Cu-V-Ta, Cu-Cr-Ti, and Cu-Cr-Ta alloys produced at 1 800°C for 6 min.
No takes yet. Share an insight, caveat, or question.
Azemar et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: