Answers are grounded in this paper and cite their sources.
Tailored hot stamping of boron steel produces automotive components with locally adapted properties. This purely numerical study, not yet validated experimentally, investigates differential tailoring of a press-hardened 22MnB5 B-pillar using coupled thermo-mechanical simulations in Simufact Forming. After austenitization at 950 °C, uniform quenching (air with dies at 20, 400 and 500 °C, water, and convective media with heat transfer coefficients of 5–60 W/m2·K) was compared with divided dies combining cooling conditions with H13 (≈27 W/m·K) or HTCS-150 (≈66 W/m·K) tool-steel segments. Maximum T85 cooling rates ranged from below 8 °C/s to above 1000 °C/s, the latter only for uniform water cooling (quenching within 2 s), giving ultimate tensile strengths from below 900 MPa to approximately 1640 MPa. In the divided dies, heat was extracted through contact with the die segments; the hard middle zone cooled at about 63 °C/s and became nearly fully martensitic (99.3–99.5% martensite, ≈512–530 HV), separated from softer zones by transition zones of approximately 13–21 mm. HTCS-150 segments enabled in-die quenching times below one minute (excluding the 300 s furnace heating). Die thermal conductivity and cooling medium are effective levers for setting the local strength distribution of B-pillars; effects on weight and crash performance were not evaluated.
No takes yet. Share an insight, caveat, or question.
Saba et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: