Answers are grounded in this paper and cite their sources.
This paper presents issues related to the feeding of thin-walled ductile iron castings. The available literature primarily focusses on feeding methods aimed at preventing casting defects or on the effect of heat extraction from the mould on the microstructure of the casting. In the present study, the results obtained for thin-walled castings produced using two different molten metal feeding methods are presented. For identical castings, the direction in which the stream of molten metal fills the mould cavity was changed, while the same gating system was used. On the basis of this approach, the relationship between the liquid metal flow direction within the mold cavity and the resulting microstructure was investigated. Two step-shaped castings with wall thicknesses of 3, 6, 9, and 12 mm were examined. Experiments were carried out using EN-GJS-450-10 ductile iron melted in an induction furnace. The moulds were produced from quartz sand bonded with synthetic furan resin. The obtained castings were analysed in terms of their chemical composition. The morphology of the graphite precipitates was evaluated according to ISO 945-1:2019, the matrix microstructure was characterised and Brinell hardness measurements were made. The experimental results were compared with the results of computer simulations conducted using MagmaSoft v. 6.0 software. Significant differences in the quality parameters of the two castings were found, depending on the feeding method employed. These differences are particularly important in the case of thin-walled castings, where the method of molten metal feeding has a substantial influence on the final microstructure and properties of the casting.
No takes yet. Share an insight, caveat, or question.
Przyszlak et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: