Answers are grounded in this paper and cite their sources.
Surface finishing governs the surface integrity of feldspathic CAD/CAM ceramics; however, the stability of finished surfaces under toothbrushing remains unclear. This in vitro study evaluated the effects of four finishing protocols (OptraFine polishing, EVE polishing, glazing, and OptraFine polishing followed by glazing) and simulated toothbrushing on the three-dimensional surface topography and wettability of this ceramic. Forty-eight disc-shaped specimens (n = 12) were analyzed before and after 20,000 brushing cycles (approximately 2 years of clinical use) using the ISO 25178 areal parameters Sa, Sz, Ssk, Sku, and Sdr and the static water contact angle, complemented by scanning electron microscopy and energy-dispersive X-ray spectroscopy (EDS). Data were analyzed using generalized estimating equations. The finishing protocol significantly affected all evaluated parameters. Toothbrushing increased Sz, Sku, and Sdr overall and significantly decreased the contact angle in all groups except the Glaze group, whereas its effect on Sa was protocol-dependent, with significant increases only in the OptraFine and OptraFine + Glaze groups. OptraFine produced the lowest Sa and remained smoother than both glazed groups after brushing. EDS suggested a compositional shift in the glazed surfaces toward that of the ceramic substrate. The complete three-step OptraFine sequence may serve as an alternative to reglazing in terms of surface roughness, whereas polishing before glazing did not reduce Sa.
No takes yet. Share an insight, caveat, or question.
Yeşil et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: