Answers are grounded in this paper and cite their sources.
BackgroundMidfoot arthrodesis is used to treat deformity, instability, and degenerative conditions. Headless compression screws may reduce hardware prominence and soft tissue irritation. We compared the biomechanical properties of conventional and headless compression screws in a modified Lapidus first tarsometatarsal joint (TMTJ) arthrodesis model.MethodsTen matched human lower extremity pairs were randomly assigned to first TMTJ arthrodesis using either 2 crossed headed 4.0-mm cannulated compression screws (HS) or two 4.0-mm cannulated headless compression screws (HLS). After bone mineral density (BMD) assessment, specimens were cyclically loaded from 0 to 31 N for 1000 cycles. Dorsal angulation and construct stiffness were measured during cyclic loading and subsequent loading to failure.ResultsMean stiffness during ultimate load testing was 58.91 ± 31.33 N/mm for headed screws and 68.36 ± 84.29 N/mm for headless screws (P = .842). Mean yield load was 115.80 ± 61.94 and 67.79 ± 35.90 N (P = .101), and mean ultimate load was 142.10 ± 65.24 and 83.02 ± 60.77 N (P = 0.064), respectively. No significant difference in dorsal angulation was observed. Mean BMD was 0.547 ± 0.222 g/cm² for headed screws and 0.533 ± 0.204 g/cm² for headless screws (P = 0.897). Bone mineral density positively correlated with construct stiffness in the headless screw group during several loading cycles, but not in the headed screw group. No significant correlations were found between BMD and yield or ultimate load.ConclusionHeaded and headless crossed screw constructs showed no statistically significant differences in stiffness, yield load, ultimate load, or dorsal angulation. However, the numerical difference in ultimate load favored headed screws. Headless compression screws may offer clinical advantages through their low-profile design, but further biomechanical and clinical studies are warranted.Clinical Relevance:Headless and headed screws showed no statistically significant differences in this cadaveric first tarsometatarsal joint model, although headed screws achieved higher mean failure loads. Their low-profile design may reduce hardware prominence and soft tissue irritation while maintaining adequate primary fixation stability.
No takes yet. Share an insight, caveat, or question.
Ortmayr et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: