Answers are grounded in this paper and cite their sources.
Cold Spray Additive Manufacturing (CSAM) is a solid-state additive manufacturing process that enables components to be produced and repaired without melting the deposited material. However, limited research has examined the weldability of CSAM components. This study investigates porosity formation and local hardness responses in CSAM 6061 aluminium joined using Tungsten Inert Gas (TIG), Metal Inert Gas (MIG), and Friction Stir Welding (FSW), considering both non-heat-treated (NHT) and heat-treated (HT) conditions. Macroscopic, micrographic, ImageJ-based porosity analysis and Vickers hardness measurements were used to characterise the welded regions. TIG and MIG produced substantial fusion zone porosity with characteristics consistent with hydrogen-assisted pore formation during melting and solidification. Pre-weld heat treatment reduced the measured two-dimensional pore area fraction from 26.3% to 18.6% for TIG and from 30.7% to 22.1% for MIG, while also altering pore size and spatial distribution. TIG exhibited relatively large, interconnected pores extending from the fusion boundary, whereas MIG showed a greater population of smaller pores concentrated towards the upper weld region. Both fusion processes produced local hardness reductions, with hardness recovery of approximately 50–56% for TIG and 63–67% for MIG relative to the corresponding control regions. In contrast, FSW exhibited substantially less macro-porosity, predominantly finer residual microporosity, and hardness recovery of approximately 82–84%. Overall, under the conditions investigated, FSW exhibited lower macro-porosity and more localised hardness reduction than TIG and MIG, while pre-weld heat treatment improved the porosity characteristics of both fusion welding processes.
No takes yet. Share an insight, caveat, or question.
Arumugam et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: