Answers are grounded in this paper and cite their sources.
To optimize the hydrophobicity of polymer surfaces, micro-V-grooved polymer surfaces were fabricated in the study by replicating the micro-V-grooved array structures of a micro-ground titanium silicon carbide (Ti3SiC2) mold core through micro-injection molding. The effects of the micro-injection molding parameters, namely melt temperature, injection speed, holding pressure and holding time, on the replication rate and surface hydrophobicity were investigated, and the wetting behavior of the micro-V-grooved polymer surfaces was analyzed. The results showed that the melt temperature had the greatest effect on the surface hydrophobicity of the polymer, whereas the holding pressure had the strongest influence on the replication rate. The measured contact angles of the micro-structured surfaces were numerically closer to the values predicted by the Cassie model than to those predicted by the Wenzel model, which indicates that the Cassie model can serve as a first-order approximation for the contact angle of such surfaces. The largest contact measured on the micro-structured polymer surface was 132.20°, which was 188.58% higher than that of the smooth polymer surface.
No takes yet. Share an insight, caveat, or question.
Zhou et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: