Answers are grounded in this paper and cite their sources.
This work presents a soft finger that combines pneumatic actuation, variable stiffness, and embedded sensing and was designed, simulated, and experimentally tested. The finger integrates a fiber-reinforced pneumatic actuator with three interconnected chambers, located at the metacarpophalangeal (MCP), proximal interphalangeal (PIP), and distal interphalangeal (DIP) joints, which generate single-input underactuated bending. The prototype was fabricated by silicone casting in 3D-printed molds and incorporates a bio-based granular filler that allows post-deformation stiffening. Bending under pressurization was simulated with the Finite Element Method (FEM) in ANSYS using hyperelastic and fiber-composite material models. The simulation reproduces the trend of the experimental bending curve, with a mean absolute difference of approximately 8.7° over the tested pressure range. Vacuum-induced granular jamming increased the stiffness (slope of the force–displacement curve) by up to 35% and the mean applied force by up to 60% relative to the unstiffened state. A microphone embedded in the fingertip recorded distinct vibration signatures on three 3D-printed textured surfaces, indicating its potential for texture sensing; texture discrimination was not quantitatively validated. These results show that finger deformation and stiffness can be controlled with minimal hardware and a simple design, supporting its use as a component in soft grippers or robotic hands.
No takes yet. Share an insight, caveat, or question.
Karagiannis et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: