Answers are grounded in this paper and cite their sources.
Conventional friction stir welding of ZE41 magnesium alloy presents challenges related to nonuniform heat distribution, weld thinning, and microstructural deterioration, which can compromise joint integrity and mechanical performance. To overcome these limitations, the present study employs indirect cooling-assisted friction stir welding (ICFSW) using a specially designed hybrid fixture to regulate heat dissipation and improve weld quality. An underground tank was fabricated and fastened to the fixture plate. Three distinct cooling media were used in the cooling tank. We tested the mechanical and metallurgical properties of the welded specimens. With the process parameters fine-tuned, the tensile test results were obtained. Tank coolant reaches its ultimate tensile strength at 400 rpm. The heat-affected zone was tested microstructurally. One of the main problems, especially in indirect-cooled friction stir welding, is that it thins out the weld and causes premature loss of material plasticity. Wrinkles and thermal quenching were reduced due to the storage tank’s consistent heating and cooling while welding. Different cooling media produced distinct microstructural characteristics in the ICFSW joints, as observed through SEM analysis. To distinguish between different microstructural zones and to measure the welded region’s hardness, microhardness was measured, which may contribute to sustainable industrialisation.
No takes yet. Share an insight, caveat, or question.
Sathish Thanikodi (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: