Answers are grounded in this paper and cite their sources.
The present study aims to optimize the machining parameters for natural fiber reinforced composites (NFRCs) using Taguchi robust design methodology for superior surface quality. The surface roughness is one of the most important indicators of the machining performance, which has a significant effect on the functional characteristics and service life of the machined composite components. The surface quality is simultaneously affected by several machining variables. Therefore, systematic optimization of the machining parameters is crucial for improving the dimensional accuracy, extending the tool life, reducing the material waste, and reducing the post-processing, and hence improving the overall manufacturing efficiency and cost-effectiveness. Jute fiber reinforced composite sample was used for experimental machining. Three levels were selected for each of the controllable machining parameter and milling experiments were performed on a CNC machining center with a 10 mm carbide end mill. The experimental design was established using the Taguchi L9 orthogonal array, which allows an efficient evaluation of the selected process variables with a limited number of experiments. The significance and relative contribution of individual machining parameters were quantified using the analysis of variance (ANOVA). The optimum machining parameters for minimization of surface roughness were found to be spindle speed of 600 rpm, depth of cut 2 mm, and feed rate 0.2 mm/rev. The most significant factor affecting the surface finish was the spindle speed, then the feed rate and the depth of cut. The spindle speed had the highest percentage contribution (58.53%) followed by the feed rate (35.95%), while the depth of cut contributed only 0.06%. The minimum surface roughness achieved under these best-performing combination conditions was 0.67μm. Additionally, a first-order multiple linear regression model was developed to describe the relationship between the machining parameters and surface roughness and to provide predictive support for the optimization process.
No takes yet. Share an insight, caveat, or question.
Kabir et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: