Answers are grounded in this paper and cite their sources.
High-precision surfaces are often ground in several separate operations because the structure of the grinding cycle is not chosen rationally, which increases allowances, setting errors and auxiliary time. This paper presents a method for the structural optimization of surface-grinding cycles in which selected stages are performed under programmed accuracy control (PC), that is, with a programmed variation of the table speed along the stroke. The result of each main stage of the cycle is described by a hypothetical state (HS) of the machined surface, characterized by its attainable size-accuracy grade, form-accuracy grade and roughness, determined from experimental data for peripheral and face surface grinding. Generalized cycles are represented by a matrix model of 13 cycle variants and by a weighted directed graph whose vertices are surface states and whose edges are cycle stages weighted by machine time or technological cost. The optimal cycle structure is the minimum-weight path that ends in a state satisfying the drawing requirements. The procedure was applied using stage durations measured experimentally in surface grinding of the slide of a through-conduit gate valve, with the durations of the PC stages obtained from a productivity coefficient: for size grade IT8, form-accuracy grade 5 and Ra 0.63 µm, the selected cycle applies PC at both the roughing and the finishing stage and requires 4.67 min, against 8.00 min for the best cycle without PC, a reduction of 41.6%. Applying the programmed control device at the roughing and finishing stages reduced the form and position errors of the ground surfaces approximately 4–5-fold. The analysis indicates that PC is most effective at the roughing stage, where the required accuracy reserve is formed, and at the finishing stage, where surface generation proceeds steadily and regularly.
No takes yet. Share an insight, caveat, or question.
Huseynov et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: