Answers are grounded in this paper and cite their sources.
High-pour-point crude oils undergo substantial rheological and phase-state changes during production as temperature decreases and pressure declines. To investigate the effects of temperature and pressure on wax precipitation and phase evolution, constant-pressure cooling experiments and constant-temperature pressure-variation PVT tests were conducted on high-pour-point crude oil under reservoir-relevant conditions. Wax appearance temperature (WAT) was estimated from viscosity–temperature curves using a two-segment linear-fitting method at 10, 20, 30, and 40 MPa, while gas–oil ratio, oil formation volume factor, density, relative volume, and saturation pressure were characterized over 50–101 °C. The viscosity–temperature curves exhibited a distinct two-stage response, with viscosity increasing gradually at higher temperatures and more rapidly during cooling as wax crystallization became significant. The calculated WAT values were 67.47, 69.82, 68.44, and 66.11 °C at 10, 20, 30, and 40 MPa, respectively, exhibiting a non-monotonic pressure dependence with a maximum variation of 3.71 °C. The PVT properties also exhibited pronounced responses to temperature and pressure. The oil formation volume factor decreased with increasing pressure and increased with temperature, whereas density showed the opposite trend. Relative volume varied gradually above the saturation pressure but increased sharply below it, indicating the transition from an undersaturated liquid state toward gas–liquid coexistence. The saturation pressure decreased approximately linearly from 8.98 MPa at 50 °C to 7.22 MPa at 101 °C. Overall, the results indicate that cooling strongly influences wax precipitation and rheological behavior, while pressure affects both WAT and gas–liquid phase equilibrium. These findings provide insights into the distinct responses of wax precipitation and PVT properties to temperature and pressure, supporting thermal management, pressure-drawdown optimization, and flow-assurance design in high-pour-point crude-oil production.
No takes yet. Share an insight, caveat, or question.
Gong et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: