Answers are grounded in this paper and cite their sources.
In this study, the mechanical, thermal, electrical, and piezoresistive performances of Gyroid lattice structures produced from multi-walled carbon nanotube (MWCNT)-reinforced PLA and ABS filaments using the fused filament fabrication (FFF) method were comparatively investigated. MWCNT was added to the PLA and ABS matrices at ratios of 3% and 5%, and Gyroid lattice-structured specimens with dimensions of 16 × 16 × 24 mm and wall thicknesses of 0.60, 0.80, and 1.00 mm were produced. The structural and thermal properties of the composites were evaluated through Fourier Transform Infrared Spectroscopy (FTIR), thermogravimetric analysis (TGA), differential thermal analysis (DTA), and differential scanning calorimetry (DSC) analyses, while their mechanical behavior was determined by uniaxial compression tests. Electrical conductivity and gauge factor variations were measured under compressive deformation, and their piezoresistive performance was analyzed. The results showed that increasing the wall thickness enhanced the compressive strength and structural stability of the Gyroid structures throughout deformation. The composites containing 5% MWCNT exhibited higher initial electrical conductivity; while the specimens produced using PLA reached higher conductivity values compared to those produced using ABS. In contrast, the highest low-strain piezoresistive sensitivity was obtained with the combination of 3% MWCNT-PLA and a 1.00 mm wall thickness. The 5% MWCNT-ABS specimens exhibited a more regular and stable gauge factor behavior over a wide strain range. The findings demonstrate that MWCNT-reinforced Gyroid lattice structures produced by FFF can be used as tunable and multifunctional piezoresistive structures that combine mechanical load-bearing capacity with deformation-sensing functionality.
No takes yet. Share an insight, caveat, or question.
Gündüz et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: