Answers are grounded in this paper and cite their sources.
Electrical discharge machining (EDM) is widely utilised non-traditional machining technique for conductive ceramic composites (CCCs), since it can machine complex geometries without imposing high mechanical strains. The impact of gap voltage (35.5–45.5 V, current (3–7A), pulse-off-time (3–7 μs), pulse-on-time (6–10 μs), and dielectric pressure (15–19 kg/cm 2 ) on the recast layer and surface morphology of Si 3 N 4 -TiN (Syalon 501) CCCs were studied by L25 orthogonal array and scanning electron microscopy (SEM). From the SEM results, it seems that the increase of current from 3 to 7 A significantly increased the discharge energy, leading to deeper craters, thicker recast layers, wider microcracks and resolidified molten droplets. Similarly, localized melting and material redeposition increased with increasing the spark-gap voltage from 35.5 to 45.5 V, resulting in an uneven surface morphology. Higher dielectric pressure (19 kg/cm 2 ) improved flushing efficiency and reduced the thickness of adherent debris and recast layer. Short pulse-off periods (3–4 μs) limited dielectric deionization, caused secondary discharges and increased debris entrapment. The surface integrity was found to be maximum at 4A, 7µs pulse-off-time, 7µs pulse-on-time, 42 V spark-gap voltage and 16 kg/cm 2 dielectric pressure. At the conditions the machined surface resulting fine craters, low microcracks, fewer microvoids and a thin continuous recast layer. The results show clearly the high dependence of the thermo-induced surface degradation on the EDM discharge parameters.
No takes yet. Share an insight, caveat, or question.
Selvarajan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: