Answers are grounded in this paper and cite their sources.
A two-way CFD–DEM calculation of the first 180 s of wheat drying in a narrow fluidized bed was examined using five-sphere rigid grains and an empirical, effective-diffusivity-based particle-average drying law. Nine nominal inlet cases (80, 100 and 120 °C; 3.0, 3.3 and 3.6 m s⁻¹) were reported. A separate literature-curve feasibility comparison (Fig. 4) used an initial moisture content of 30% dry basis, an inlet velocity of 3.3 m s⁻¹ and an inlet temperature of 373.15 K; it is not one of the nine 25%-dry-basis simulations. The 80 and 100 °C results describe model-conditioned early heating and moisture-loss trends; the 120 °C drying histories are affected by a numerical |dM/dt| ceiling of 8.0 × 10⁻⁴ s⁻¹ and cannot establish uncapped kinetics. The sensitivity and consistency analyses in Sections 2.4.2–2.4.3 address effective diffusivity, internal diffusion resistance, particle-side mass and energy exchange, the empirical heat-transfer correction factor, and the drying-rate ceiling. These analyses are diagnostics, not new fully coupled CFD–DEM runs. The available evidence supports comparative model behavior but does not establish grid convergence, solver-wide conservation, or independent predictive validation.
No takes yet. Share an insight, caveat, or question.
Xia et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: