Answers are grounded in this paper and cite their sources.
Polyetherimide (PEI)‐based composites for sliding components at elevated temperatures require simultaneous heat dissipation and wear resistance, whereas conventional particulate reinforcement often cannot effectively provide both functions. In this work, hierarchical Al 2 O 3 /boron nitride nanosheets (BNNSs)/PEI composite films were fabricated by electrospinning followed by hot pressing. Compared with conventional blending and casting, this route can better confine and orient the fillers and construct hybrid architectures for thermal transport and sliding interfaces while suppressing agglomeration and nanosheet restacking. The effects of filler composition on fiber morphology, thermal conductivity, and dry‐sliding tribological behavior were systematically investigated. The 5% Al 2 O 3 /5% BNNSs/PEI composite exhibited the best overall performance. At room temperature, its steady‐state coefficient of friction reached approximately 0.26 and its specific wear rate was reduced by 76.2% relative to neat PEI. At 100°C under a load of 5 N, the composite maintained a coefficient of friction of approximately 0.35 and showed a 46.9% reduction in wear rate. Its thermal conductivity reached 0.422 W m −1 K −1 at 100°C. Wear‐track and counterpart‐surface observations indicate that the hybrid fillers promote a more stable transfer film, while BNNS‐containing transport pathways facilitate frictional‐heat dissipation. These results establish a processing–structure–property strategy for developing PEI‐based composites with combined thermal‐management and wear‐resistant functions under elevated‐temperature sliding conditions.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: