Answers are grounded in this paper and cite their sources.
In this study, the development, fabrication, optimization, and mechanical characterization of hybrid lattices for protective applications is presented. Ten lattice configurations, including BCC, FCC, Diamond, Octet, and hybrid lattice configurations (BCC + FCC, Diamond + BCCZ, Diamond + Octet, Diamond + FCCZ, Octet + BCCZ, and Octet + FCCZ), were investigated based on Maxwell's Criterion for deformation behavior classification into bending and stretching. The finite element analysis (FEA) of 40 lattices of truss diameter 3–9 mm was carried out to study stress distribution, displacement, stiffness, and load-carrying ability of the selected lattice configurations. Based on the obtained initial numerical results, three stretching dominated lattices Octet + Diamond, Octet + BCCZ, and Octet + FCCZ were fabricated using stereolithography (SLA) and experimentally investigated under compression and tension by means of a Universal Testing Machine equipped with Digital Image Correlation (DIC). The most mechanically efficient lattice was found to be Octet + Diamond with maximum compressive load of 1450 N. The hybrid lattices were optimized through an ML-based multi-objective optimization approach, using GPR and Pareto optimization, to find the Octet + Diamond lattice topology with a truss diameter of 9 mm as the best-performing design under unconstrained circumstances. As a result of the study using the non-linear elastic-plastic FEA approach, linear FEA was found to have overestimated the peak stress of the post-yield zone by about 2–3 times, but accurately determined the locations of stress concentrations and the ranking of the different lattice topologies studied. However, by setting a realistic von Mises stress constraint of σvm ≤ 32.5 MPa with a safety factor of 2.0 for the upper-bound yield strength of the SLA resin material, it became impossible to find any viable configuration within the studied range of 3–9 mm diameter range. This is indicative of a limitation on the part of the material itself to be utilized in such applications with the conventional SLA resin materials.
No takes yet. Share an insight, caveat, or question.
Jilani et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: