Answers are grounded in this paper and cite their sources.
This work presents a study on the feasibility of determining Na, Mg, Cl, K, Ca, Br, and Sr contents in brine samples using a benchtop energy-dispersive X-ray fluorescence spectrometer (ED-XRF). A 10 mL aliquot of the sample was poured into a sample cap with a bottom covered by a polypropylene film. Measurements were carried out on an X-Supreme 8000 X-ray fluorescence analyzer equipped with a W-anode X-ray tube (3 W) and a silicon drift detector with a resolution of ~150 eV at the Mn K α line (5.9 keV), using helium purge of the spectrometer chamber to enable detection of light elements. The samples under study were chloride calcium brines with total mineralization ranging from 40 to 564 g/dm 3 , whose composition had been previously determined by classical chemical methods commonly employed for the analysis of high-mineralized waters. Processing of the measurement results for calibration samples using multiple regression revealed significant interelement effects, indicating the necessity of accounting for matrix element content. It was found that conversion from volumetric concentrations (g/dm 3 ) to mass fractions (g/kg) reduces the calibration error by a factor of 1.5 – 2 for most elements. Optimal calibration equations were selected, providing minimum residual relative standard deviation values (%) of: Na — 18; Mg — 3.5; Cl — 2.3; K — 9.7; Ca — 5.4; Br — 5.8; Sr — 3.7. Additionally, it was shown that the intensity of scattered primary radiation from the X-ray tube can be used to estimate brine density with an error of less than 2%. Thus, the proposed ED-XRF method can be employed for rapid quantitative determination of major elements and density in brine samples without prior dilution and without the use of additional reagents.
No takes yet. Share an insight, caveat, or question.
Finkelshtein et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: