Answers are grounded in this paper and cite their sources.
A method for thermal friction diagnostics is presented. This approach enables determination of the time-dependent friction torque in a plain bearing with reciprocating shaft motion, which exhibits distinct characteristics compared to that of a rotary bearing. The method relies on the principle that nearly all energy dissipated through friction is converted into heat. Determining the friction torque is formulated as an inverse problem of identifying frictional heat generation, a process sensitive to minor errors in temperature measurements. An iterative regularization technique is employed to estimate the friction torque from temperature data, achieving accuracy comparable to that of the temperature measurements. The influence of temperature sensor placement relative to the friction zone on torque identification is examined. Results indicate that temperature oscillations arising from energy transfer during reciprocating shaft motion are negligible in thermal diagnostics. Experimental validation was performed using a setup based on a 2070 SMT-1 friction machine with a rotary shaft, modified to implement reciprocating motion and record time-dependent temperature and friction torque data. Temperature measurements were acquired at 100 Hz using an L-Card 502 multifunctional module. Friction torque time functions were obtained both by solving an inverse heat conduction problem and through direct measurement with a weighing strain gauge and analog-to-digital converter. The deviation between friction torque values determined by these fundamentally different methods did not exceed 10 – 15%.
No takes yet. Share an insight, caveat, or question.
Starostin et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: