Answers are grounded in this paper and cite their sources.
This analysis demonstrates cold spray coating enhances joint strength in aluminum and magnesium, suggesting a viable method for dissimilar welding.
Direct fusion welding of aluminum (Al) to magnesium (Mg) results in the formation of brittle intermetallic compounds (IMCs) that significantly restrict the application of these joints in structural applications. In this study, cold spray, a promising solid-state coating deposition technology, was employed to introduce a nickel (Ni) interlayer to facilitate joining of Al to Mg sheets by means of resistance spot welding (RSW). The ability of cold spraying to deposit metallic powder on the substrate without melting proves beneficial in mitigating the formation of the Al-Mg IMCs. The Ni-coated coupons were subsequently welded via resistance spot welding at optimized parameters: 27 kA for 15 cycles in two pulses with a 5-cycle inter-pulse delay. Scanning electron microscopy confirmed metallurgical bonding between the Al, Mg, and Ni coatings in the fusion zone. It is shown that the bonding between the three elements inhibits the formation of deleterious IMCs. Tensile shear testing showed joint strength exceeding 4.2 kN, highlighting the potential of the proposed cold spray RSW approach for dissimilar joining in structural applications.
No takes yet. Share an insight, caveat, or question.
Oheil et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: