Answers are grounded in this paper and cite their sources.
Fe-based coatings containing hard secondary phases are a cost-effective alternative to Co- and Ni-based hardfacings for improving the wear resistance of steel components. A gas-atomized Fe-M(Nb,Mo,Cr)-C-B alloy was consolidated onto AISI 4140 steel by hot pressing at 1050 °C for 30 min under 50 MPa, producing a coating approximately 1 mm thick. X-ray diffraction of the powder and the consolidated coating identified an α-Fe matrix with M7(C,B)3 and M(C,B) secondary phases. The coating-substrate interface was continuous, with a narrow interdiffusion zone. Statistical nanoindentation gave 14.2 ± 4.4 GPa for the coating and 10.5 ± 1.3 GPa for the substrate. Under dry-sliding conditions, the coating exhibited a specific wear rate of (1.5 ± 0.4) × 10−6 mm3 N−1 m−1, approximately 26 times lower than that of AISI 4140 ((3.9 ± 1.9) × 10−5 mm3 N−1 m−1, 20 N, three tests per material), and a lower mean coefficient of friction (0.45 ± 0.06 vs. 0.54 ± 0.10). Worn-surface analysis indicated mild oxidative and micro-abrasive wear of the coating, in contrast to the adhesive-abrasive wear of the substrate. These results make the alloy a promising feedstock for wear-resistant powder-based coatings.
No takes yet. Share an insight, caveat, or question.
Yavuz et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: