Origins and optimization mechanisms of periodic microstructures in Al-Cu alloys fabricated by wire arc additive manufacturing combined with Interlayer Friction Stir Processing

Inter-layer Friction Stir Processing on Arc Additive Manufactured Components offers significant potential for performance enhancement, yet the homogenization of microstructures has become a challenge for industrial application. To address this, 2319 Al-Cu alloy components were fabricated through the Wire Arc Additive Manufacturing + Interlayer Friction Stir Processing (WAAM-IFSP) 1 technique, and a systematic study was conducted on the effects of deformation degree , deformation temperature , and strain rate changes on the microstructural evolution , revealing three distinct periodic microstructures. An increase in deformation degree resulted in a uniform periodic microstructure, attributed to the more uniform internal deformation caused by the increased deformation degree. At a deformation degree of 24.1 %, higher strength and ductility were achieved, along with a notable bimodal grain structure (BGS). Further research indicated that this structure would distribute more widely within the matrix with increasing strain rate, aiding in further performance breakthroughs, ultimately reaching an ultimate tensile strength (UTS) of 404 MPa and an elongation (EL) of 32 %. However, imperfections in the process led to inhomogeneity in the structure. Focusing on the dynamic recrystallization (DRX) mechanisms during stirring can improve this phenomenon. The research revealed that the fine grains in the BGS were controlled by a synergy of dominant discontinuous dynamic recrystallization (DDRX) and auxiliary continuous dynamic recrystallization (CDRX) nucleation mechanisms . The findings are expected to provide a theoretical basis for the optimization of WAAM-IFSP processes and microstructural and performance regulation, which is crucial for enhancing the industrial application prospects of aluminum alloys . • Through the control of the WAAM-IFSP process, three types of periodic microstructures were obtained. • Without subsequent heat treatment, the strength of 2319 aluminum alloy exceeded 400 MPa. • The nucleation mechanisms of DDRX and CDRX coexist, with the former being dominant. • An optimization scheme for periodic microstructures was proposed.