Answers are grounded in this paper and cite their sources.
The steel–concrete composite girder bridge with steel truss webs consists of top and bottom concrete slabs, steel truss web rods, and internal and external prestressed beams. The steel truss web rods are connected to the top and bottom concrete slabs via nodes. This bridge configuration boasts lightweight construction, minimal on-site welding requirements, and high permeability. It is easily detectable and maintainable. However, owing to the discontinuous steel web rod structure, the mechanical behavior of the concrete slab differs significantly from that of traditional continuous web box girders. To investigate the shear lag effect on the steel–concrete composite girder with steel truss webs under multipoint support conditions, this paper examines the longitudinal and transverse stress distribution patterns of the concrete slab subjected to symmetrical loads through model tests. By combining numerical simulation with comparative analysis of shear lag phenomena in the steel truss web node area, a calculation formula for the shear lag coefficient of steel–concrete composite girder with steel truss webs is derived using the variation method. Furthermore, considering the impact of steel truss web rod joints, a concrete slab stress calculation method based on linear superposition of local node axial force and vertical force is proposed. Results indicate that due to the action of the steel truss web rod fulcrum, the stress on the concrete slab exhibits a wave-shaped variation, with stress mutation occurring at the nodes, and positive and negative shear lag is observed in the concrete slab. The variation method, treating the steel truss web rods as continuous webs, accurately predicts midspan shear lag and shear lag at the supports, consistent with test values. However, significant discrepancies exist between calculated and tested values for other sections between spans. The method proposed in this paper decomposes the action of web rod nodes into vertical force and axial force, facilitating superposition calculations of concrete slab stress, which align well with experimental results and better represent wave-shaped changes in longitudinal strain distribution for this bridge configuration.
No takes yet. Share an insight, caveat, or question.
Liu et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: