Key result
3D-STE correlates moderately with CMR for longitudinal strain-volume analysis.
Why the study?
Does three-dimensional echocardiography strain-volume analysis provide comparable measurements to tagging cardiac magnetic resonance in healthy subjects?
Cross-Sectional (n=23)
Does three-dimensional echocardiography strain-volume analysis provide comparable measurements to tagging cardiac magnetic resonance in healthy subjects?
Effect estimate: r = 0.65
p-value: p=0.001
Longitudinal strain-volume analysis performed with three-dimensional speckle-tracking echocardiography is closely comparable with cMR for volume and function assessment.
Supports 3D speckle-tracking for strain-volume analysis in healthy subjects; leaves open validation in patients and clinical outcomes.
OBJECTIVE: The aim of this study is to compare three-dimensional echocardiography strain-volume analysis with tagging cardiac magnetic resonance (cMR) measurements. BACKGROUND AND METHODS: Strain-volume analysis represents a noninvasive method to assess myocardial function and volumes simultaneously. It can be derived from echocardiography and speckle-tracking; however, it shows some variability that can limit clinical utilization. A three-dimensional approach partially overcomes these limitations since full-volume acquisition avoids images being foreshortened and geometrical reconstruction. In the study presented here, 23 healthy subjects were studied by three-dimensional echocardiography and cMR during the same session. Images were stored and the better cardiac cycle was chosen for simultaneous analysis of volumes and longitudinal (Long) and circumferential (Circ) strain. By means of full-volume acquisition all parameters can be calculated for each frame of the cardiac cycle using the speckle-tracking method. With cMR, left ventricle volumes were calculated as recommended; myocardial strains were computed in short-axis and long-axis views using the tagging technique. For each patient, volumes and strain values were plotted in a Cartesian system for strain-volume analysis. Data were compared between the two methods using Bland-Altman analysis based on mean difference and 95% limits of agreement (LoA). RESULTS: The volume as measured by three-dimensional echocardiography and cMR was comparable with the slightly higher end-diastolic volumes measured by cMR (mean difference 15.24 ml; LoA -53.6 to 26.5 ml, end-systolic volume 0.3 ml; LoA -19.9 to 20.5 ml). Long shortening was very similar in the two methods (1.5%; LoA -3.9 to 7%), whereas Circ strain was systematically lower with cMR (-8.5%; LoA -15.5 to -1.5%). Very similar values between three-dimensional echo and cMR both for Slope of strain-volume curves (-0.015; LoA -0.08 to 0.05) and ratio (-0.001; LoA -0.04 to 0.04) were observed in the longitudinal plane. Analysis of strain-volume per patient showed a significant correlation coefficient between techniques for both Long Slope (r = 0.65; P = 0.001) and Long Ratio (r = 0.70; P = 0.001). CONCLUSION: Longitudinal strain-volume analysis performed with three-dimensional speckle-tracking echocardiography is closely comparable with cMR, which is usually considered the gold standard for volume and function assessment.
No takes yet. Share an insight, caveat, or question.
Lilli et al. (2015) conducted a cross-sectional in Healthy subjects (n=23). Three-dimensional echocardiography strain-volume analysis vs. Tagging cardiac magnetic resonance (cMR) was evaluated on Correlation of longitudinal strain-volume analysis (Long Slope) between 3D echocardiography and cMR (r = 0.65, p=0.001). Longitudinal strain-volume analysis using three-dimensional speckle-tracking echocardiography significantly correlated with cardiac magnetic resonance for Long Slope (r=0.65; P=0.001).
Synapse has enriched 5 closely related papers on similar clinical questions. Consider them for comparative context: