Answers are grounded in this paper and cite their sources.
Investigates mechanical performance and rheology of mortars with sand replacement using stone powder, suggesting optimal use for sustainable 3D printing.
The valorization of stone powder (SP), a by-product of marble and limestone processing, presents a promising pathway for sustainable material design in extrusion-based 3D concrete printing (3DCP). However, its influence on the coupled rheology-buildability-mechanical performance remains insufficiently understood. This study systematically investigates sand replacement (0–100% by weight) with SP in printable mortars under controlled workability conditions. Particle characterization (D10 = 0.56 µm, D50 = 8.9 µm, D90 = 256 µm; SEM/EDS confirming angular CaCO₃ morphology) reveals its strong influence on particle packing and interparticle friction. Rheological properties (yield stress, viscosity, hysteresis area) evaluated at 20 minutes post-mixing exhibit a non-linear response with increasing SP content. The results demonstrate a transition from a particle packing dominated regime at moderate SP content to a rheology-controlled regime at higher replacement levels. While lower SP contents (20–32%) provide higher mechanical strength, a replacement level of approximately 43% SP offers the best balance between rheological properties, buildability, and structural performance. A performance-based design window of 20–43% SP is identified for optimized 3D printing applications. Findings reveal that buildability is governed by the combined interaction of yield stress, viscosity, and packing density, rather than any single parameter, offering a mechanistically informed framework for material design in 3DCP.
No takes yet. Share an insight, caveat, or question.
Joshi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: