Answers are grounded in this paper and cite their sources.
Examines tribological performance of bionic-inspired Babbitt alloys, suggesting improved wear resistance.
Babbitt alloy is widely used in low-speed and heavy-load bearings for its excellent antifriction and wear resistance. Accordingly, the Babbitt alloy containing uniformly distributed coarse-grained(CG) SnSb phase was designated as babbitt-zc, whereas the counterpart with uniformly distributed fine-grained(FG) SnSb phase was defined as babbitt-zr. The laser-remelted specimens exhibited alternating CG and FG regions, with CG2/FG3 and CG1/FG2 microstructures marked as babbitt-cre and babbitt-zrm, respectively. The results indicated that the microstructure of the Babbitt alloy evolved from a single coarse SnSb grain zone to a single refined SnSb grain zone, and finally to an alternating distribution of coarse-grained and fine-grained regions. For babbitt-cre and babbitt-zrm microstructures, compared with coarse-grained zone of Babbitt alloy, microhardness of fine-grained region was increased about 37.26%. The simulation result of strain and stress of babbitt-cre(8.82×10−5 mm, 4.23 MPa) and babbitt-zrm(8.51×10−510−5 mm, 4.08 MPa) were lower than those of babbitt-zc(8.89×10−5 mm, 4.26 MPa). It was demonstrated that the alternating distribution of coarse-grained and fine-grained regions was beneficial to improving the tribological properties of Babbitt alloy under lubricated condition. Moreover, compared with babbitt-zrm, babbitt-cre exhibited markedly improved tribological performance under lubricated condition. Furthermore, babbitt-cre showed a 27.92% reduction in wear rate and a 27.16% reduction in friction coefficient compared with babbitt-zrm at 5N.
No takes yet. Share an insight, caveat, or question.
Ni et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: