Answers are grounded in this paper and cite their sources.
Corneal thickness has become a limiting factor in successful and safe laser in situ keratomileusis (LASIK). If the cornea is thinned too much by the procedure, iatrogenic keratectasia can occur. Decreased corneal thickness increases the surface-parallel stress.1 Iatrogenic keratectasia is a major complication of LASIK and is a concern to patients and refractive surgeons.2 Although it is most likely to appear after excessively deep central corneal ablations, iatrogenic keratectasia can occur after shallow ablations.3 Theoretically, for a safe LASIK procedure, a stromal bed thickness of at least 250 μm should remain after the microkeratome cut and excimer ablation.4 But do we really know whether 250 μm is the appropriate residual stromal thickness for all LASIK patients to prevent keratectasia? Corneal mechanics vary among different individuals and different corneas. Different residual bed thicknesses may be appropriate for different corneas. Seiler1 recently questioned whether it would be safer to use a percentage of corneal thickness as the minimal residual stromal thickness rather than an absolute number (250 μm), given errors in ultrasound pachymetry measurements and biomechanical considerations. Three factors influence the postoperative residual stromal bed thickness after LASIK: the preoperative corneal thickness, the flap thickness achieved by the microkeratome cut, and the excimer stromal ablation. In this issue, Yildirim at al. evaluate the reproducibility of flap thickness during LASIK using a Hansatome microkeratome and a 180 μm microkeratome plate. Surprisingly, they found a mean flap thickness of 120.87 μm ± 26.37 (SD) with a range of 64 to 191 μm. In the series, the residual bed would have been thicker than predicted from simple preoperative calculation. However, if the flap thickness were thicker than the predicted value, as found in other studies,5 residual stromal thickness would be thinner and iatrogenic keratectasia might occur more often, especially in eyes in which the planned residual corneal thickness was 250 μm. To accurately predict the postsurgical residual stromal thickness after LASIK, we have to know the stromal bed thickness following the microkeratome cut or the intraoperative flap thickness (to subtract this value from the preoperative total corneal thickness), as well as the ablation depth. New methods such as continuous noncontact corneal pachymetry with a high-speed reflectometer6–8 have been proposed to determine this information. Most LASIK surgeons do not routinely measure stromal thickness intraoperatively. Although iatrogenic keratectasia might be a rare condition if the theoretical calculation as described above were accepted and followed, we must be sure that it will be avoided after all cases of refractive surgery. Routine intraoperative measurement of corneal thickness would enable us to study the etiology of iatrogenic keratectasia better and cancel the excimer ablation intraoperatively if the residual stromal bed were found to be too thin. The safety of LASIK will be tremendously increased if on-line monitoring during the procedure becomes a routine step in LASIK surgery.
No takes yet. Share an insight, caveat, or question.
Thomas Kohnen (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: