Answers are grounded in this paper and cite their sources.
Shows improved corrosion resistance in Cu with phosphorus-modified Sn coatings, highlighting effective barrier properties.
To improve the corrosion resistance of Sn coatings on Cu substrates in chloride-containing environments, pure Sn and Sn–P coatings containing 0.02, 0.05, and 0.08 wt.% P were prepared by hot-dip coating. Their surface morphology, surface-film chemistry, and corrosion behavior were characterized using electrochemical measurements, atomic force microscopy (AFM), scanning electron microscopy coupled with energy-dispersive X-ray spectroscopy (SEM/EDS), and X-ray photoelectron spectroscopy (XPS). The results demonstrate that trace phosphorus addition enhances the electrochemical stability of Sn coatings prepared via the hot-dip method. The corrosion current density decreased from 1.55 × 10−6 A·cm−2 for pure Sn to 3.28 × 10−7 A·cm−2 for SnP0.02, corresponding to a reduction of approximately 79%. Meanwhile, the total resistance increased from 10.46 to 19.03 kΩ·cm2, confirming the enhanced barrier effect of the surface film. AFM results showed that the surface roughness Ra decreased from 13.41 nm for pure Sn to 8.72–12.69 nm for the Sn–P coatings. XPS identified Sn–O, P–O, and Sn–P species, suggesting the formation of a Sn–O/P–O-containing protective film. SnP0.02 exhibited the best overall corrosion resistance, whereas excessive P promoted local P-rich regions and non-uniform film formation, limiting further improvement.
No takes yet. Share an insight, caveat, or question.
Wang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: