Answers are grounded in this paper and cite their sources.
This article presents an experimental investigation on microdrilling of austenitic stainless steel which is a difficult material for machining because of its properties like high strain-hardening rate, low thermal conductivity, and high fracture toughness. Microholes are produced on X5CrNi18-10 austenitic stainless steel workpiece using 0.5 mm diameter solid carbide microdrills. Two factors (cutting speed and feed) and three levels (low–center–high) full-factorial design of experiment are performed. Response surface methodology is used to developed mathematical models (quadratic and bilinear regression models) for cutting forces in microdrilling. The experimental analysis shows that feed affects the cutting force components (radial and thrust) significantly. Additionally, it also shows that there are only minor effects from cutting speed, square of cutting speed, square of feed and product of speed, and feed on the cutting forces. Finally, the optimized cutting conditions are proposed for minimum cutting forces.
No takes yet. Share an insight, caveat, or question.
Patra et al. (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: