Answers are grounded in this paper and cite their sources.
Although inorganic resists are characterized by high contrast and resolution, they have traditionally suffered from poor sensitivity. We have investigated the use of a rare-gas halide excimer laser operating at λ = 249 nm to expose the inorganic resist Ag2Se/GeSe2. Well-controlled lines and spaces, each of 0.5-µm width, were contact printed using a chromium-on-quartz mask. By increasing the peak dose rate to about 520 kW/cm2, we found that the required dose could be lowered from 130 to 5.2 mJ/cm2; this sensitivity is a factor of 250 better than that obtained with exposures at λ = 436 nm and low power densities. The reciprocity failure at these high flux rates can be explained by a locally induced temperature rise.
No takes yet. Share an insight, caveat, or question.
Polasko et al. (1984) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: