Answers are grounded in this paper and cite their sources.
The co-processing of deoxygenated pyrolysis bio-oil with vacuum gas oil was studied in a hydroprocessing pilot plant. The bio-oil used as the biogenic component of the feed was produced by fast pyrolysis of forest biomass and pretreated via hydrodeoxygenation to improve its chemical stability. Two blends containing 5 and 7.5% deoxygenated bio-oil in hydrotreated vacuum gas oil were tested for hydrocracking at reaction temperatures of 385–400 °C, including tests with pure vacuum gas oil to establish a baseline for the study. Testing over 2154 catalyst hours showed that pyrolysis bio-oil co-processing did not impact much baseline hydrocracking selectivity, yielding similar amounts of naphtha and diesel at a given conversion of material boiling above 343 °C, but with increasing hydrogen consumption levels proportional to the amount of bio-oil in the feed. Periodic monitoring of catalyst stability during continuous operation showed no signs of enhanced catalyst aging as a result of co-processing the pyrolysis bio-oil blends. Characterization of the distillation fractions from the hydrocracked liquid products revealed differences in hydrocarbon-type composition and fuel properties for the same product streams from different bio-oil blends. The naphtha fraction from the 7.5% co-processing blend showed better octane number with respect to the other naphtha products, owing to its reduced paraffinic content. The diesel products from the two co-processing blends were slightly higher in aromatic content than the baseline diesel product, which caused a loss in cetane index. This study suggests that it is feasible to co-process pyrolysis bio-oil through hydrocracking provided that it has undergone pretreatment to stabilize reactive oxygen components.
No takes yet. Share an insight, caveat, or question.
Alvarez‐Majmutov et al. (2021) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: