This is the authors' abstract. We don't add key points for this paper.
Quantum wires ≊300–400 Å wide were fabricated by holographic photolithography from a wafer having a single 100 Å InGaAs quantum well. The wires were then recoated with InP using atmospheric pressure organometallic vapor phase epitaxy, which resulted in a planar surface. A high-resolution scanning electron microscope showed little deterioration of the wires due to recoating. At moderate intensities ≊10 W/cm2, photoluminescence (PL) studies showed a small shift in energy (≊6 meV) and a slight line narrowing consistent with a one-dimensional structure. The quantum efficiency of the wires was comparable to the control wafer—above that expected from the fill factor of 17%. Some evidence of states below the energy gap is seen at low PL excitation, but these appear to saturate at higher excitations.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Miller et al. (1989) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: