Answers are grounded in this paper and cite their sources.
Quartz has been widely used as a standard for the calibration of Debye-Scherrer X-ray powder cameras, and hence for the measurement of crystal lattice constants in terms of Siegbahn's wave-length scale. The quartz standard was first proposed by Bradley and Jay, who assumed the spacing derived from Bergqvist's measurements, and determined the axial ratio, and hence c , by means of the camera designed by Bradley. A later direct determination of c by Elg, however, is not consistent with the value of c as derived above. The present paper describes a determination of both a and c in terms of the wave-length scale, using Debye-Scherrer cameras. The results, a =4.903 2 A. and c =5.393 7 A. at 18° C., agree very closely with the value of c obtained by Elg and the axial ratio of Bradley and Jay, but indicate that Bergqvist's value of a is low by about one part in 20 000. The revised values of the unit cell dimensions should be adopted when quartz is used to calibrate a camera, so a table of angles of reflection is given. Our results indicate however, that a higher accuracy can be obtained by direct measurement of the camera.
No takes yet. Share an insight, caveat, or question.
Wilson et al. (1941) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: