Answers are grounded in this paper and cite their sources.
Many different approaches have been made to describe the phenomenon of lipolysis in milk and other dairy products, and numerous methods have been used to measure lipase activity.The data accmnulated in the literature as the result of these varied methods of experimentation appear to be somewhat confusing and in some disagreement.A partial explanation for the diversity in results lies in the variety of methods used, as well as inadequate control of experimental conditions in some instances.Of perhaps greatest importance in regard to the latter point is the poor control of enzyme source and co~centration.Raw milk has most often been used as the source of lipase, and it is natural to assume that the enzymes in milk, like other constituents, are subject to wide fluctuations iu amount from one sample to another.Therefore, it seemed necessary, particularly for a study of enzyme kinetics, to develop a potent and stable lipase preparation to permit comparison of experiments under a variety of conditions over relatively long periods of time.The work of Pfeffer et al. (3) indicated that separator slime was an excellent source of lipase and us~mlly showed about three times as much lipolytic activity as normal milk.Accordingly, this work was undertaken to procure from separator slime highly concentrated lipase preparations in a physical state that would provide ease of handling and a source of enzyme that would remain constant in concentration and other properties. EXPERIMENTAL METI-IODS~qo~trce and preparation of milk prod~tcts.All milk products used in this study were obtained from milk produced by the University of 5{innesota dairy herd.The cream, skimmilk, and separator slime were prepared by warming approximately 30 gal. of raw milk to a temperature of 32 ° to 35 ° C. and passing it through a warm milk separator.The cream and skimmilk were passed over a surface cooler and cooled to 4.5 ° C., and all three materials were stored at 0 ° C. until tested.The separator slime was collected immediately after completion of separation and held at 0 ° C. until utilized in experiments.The method employed to test lipase activity was very similar to that used by Peterson et al. (2).One change was the use of 5.8 ml.rather than 2.0 ml. of 0.6 M sodium barbital in order to increase the buffering capacity of the substrate suspension.The titration was done with aqueous 0.1 N sodimn hydroxide.
No takes yet. Share an insight, caveat, or question.
Nelson et al. (1955) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: