Answers are grounded in this paper and cite their sources.
Simulation study demonstrates that polybenzoxazole PCB dielectric significantly lowers GaN transistor junction temperatures, highlighting dielectric choice as a key thermal-design parameter.
GaN power devices used in high-power-density converters face significant thermal-management challenges because substantial heat is generated within a compact active region and transferred through the device–Printed Circuit Board (PCB) interface. This study investigates the influence of PCB dielectric-material selection on the coupled thermal and electrical behavior of a 48 V/12 V GaN half-bridge converter. Flame Retardant 4 (FR4), Hydrocarbon ceramic laminate material RO4000 series (4003) (RO4003), and polybenzoxazole (PBO) were compared using a reduced steady-state thermal-resistance network, three-dimensional finite-element simulations in Ansys Icepak, parasitic-capacitance extraction in Ansys Q3D, and switching simulations in LTspice. Both analytical and numerical models produced the same thermal-performance ranking, with PBO providing the lowest junction temperature. Under identical geometry, power dissipation, and boundary conditions, the Finite Elements Method (FEM) results showed a reduction in the maximum junction temperature from 225 °C for FR4 to 159 °C for PBO. The extracted layout-associated capacitances were also reduced by approximately 30–38% with PBO relative to FR4. This decrease produced a slight reduction in the switching-node falling time and lowered the calculated transistor loss from 3.118 W to 3.102 W. The results show that PCB dielectric selection is primarily a thermal-design parameter, while its electrical influence remains modest under the investigated operating conditions.
No takes yet. Share an insight, caveat, or question.
Belguith et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: