Answers are grounded in this paper and cite their sources.
A silicon PIN diode developed for use as a microwave protector promises to have considerably greater reliability than gas T-R tubes. The switching action of the device results from the lowering of I layer resistance by conductivity modulation, caused either by sufficiently high microwave power levels or by applied dc bias. A theoretical analysis is presented here which yields equations for I layer resistance as a function of excitation (dc bias or microwave power). Predictions are made about the relative effectiveness of direct current or microwave power in modulating the I layer; for example, 100 ma dc bias should produce about the same injected carrier concentration as 100 kw of microwave power at 1 Gc. An experimental X-band protector consisting of an appropriately tuned PIN diode connected across a waveguide presented to low level signals an insertion loss 1 db or less when zero biased, and an insertion loss of up to 34 db at 100 ma forward bias. Measurements of temperature rise in the wafer as a function of applied X-band power indicated that the diode could protect against microwave pulses with energies of up to 38 Mw-µsec before burnout, in good agreement with theoretical predictions.
No takes yet. Share an insight, caveat, or question.
D. Leenov (1964) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: