Answers are grounded in this paper and cite their sources.
This paper presents a scalable 28-GHz phased-array architecture suitable for fifth-generation (5G) communication links based on four-channel (2×2) transmit/receive (TRX) quadcore chips in SiGe BiCMOS with flip-chip packaging. Each channel of the quad-core beamformer chip has 4.6-dB noise figure (NF) in the receive (RX) mode and 10.5-dBm output 1-dB compression point (OP1dB) in the transmit (TX) mode with 6-bit phase control and 14-dB gain control. The phase change with gain control is only ±3°, allowing orthogonality between the variable gain amplifier and the phase shifter. The chip has high RX linearity (IP1dB = -22 dBm/channel) and consumes 130 mW in the RX mode and 200 mW in the TX mode at P1dB per channel. Advantages of the scalable all-RF beamforming architecture and circuit design techniques are discussed in detail. 4and 32-element phased-arrays are demonstrated with detailed data link measurements using a single or eight of the fourchannel TRX core chips on a low-cost printed circuit board with microstrip antennas. The 32-element array achieves an effective isotropic radiated power (EIRP) of 43 dBm at P1dB, a 45-dBm saturated EIRP, and a record-level system NF of 5.2 dB when the beamformer loss and transceiver NF are taken into account and can scan to ±50° in azimuth and ±25° in elevation with <; -12-dB sidelobes and without any phase or amplitude calibration. A wireless link is demonstrated using two 32-element phased-arrays with a state-of-the-art data rate of 1.0-1.6 Gb/s in a single beam using 16-QAM waveforms over all scan angles at a link distance of 300 m.
No takes yet. Share an insight, caveat, or question.
Kibaroglu et al. (2018) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: