Answers are grounded in this paper and cite their sources.
Hydrogenated amorphous silicon (a-Si:H) films having a thickness of 7 μm were deposited on molybdenum by dc glow discharge and then capped with a 0.1-μm-thick aluminum (Al) layer by thermal evaporation. Subsequent vacuum annealing at 500–725 °C resulted in the formation of crystalline Si, as observed by Raman scattering and x-ray diffraction. This was in contrast to the uncapped a-Si:H films which were still amorphous at the same annealing temperatures, except at ≳700 °C. That the Al capped films were crystalline caused a ten-fold increase in the dark conductivity in comparison to the uncapped film annealed at the same temperature. The capped films annealed at 500 °C showed a photoresponse (the ratio of the photoconductivity to dark conductivity) of 30, a photoconductivity of 2×10−4 (Ω cm)−1, and a carrier diffusion length of 5.3 μm—values much higher than those of the uncapped films (heated or not). This was due to a large grain size combined with the retention of hydrogen, which passivated the grain boundaries. On the other hand, a significant loss of hydrogen from the capped film at 580 °C, as observed by in situ evolved gas analysis, resulted in the diffusion length reducing to 1.8 μm and ten-fold decreases of the photoconductivity and photoresponse. All three parameters increased slightly with a further increase in the annealing temperature from 600 to 680 °C, due to the increase in the grain size. At 695 °C, further hydrogen evolution caused a sharp decrease in the values of these parameters.
No takes yet. Share an insight, caveat, or question.
Sridhar et al. (1995) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: