Key result
The use of rapid prototyping anatomical models significantly improved the cardiologist's confidence in patient selection, prosthesis fabrication, and final implantation for pulmonary valved stents.
Why the study?
Does the use of rapid prototyping models improve cardiologist confidence in planning percutaneous pulmonary valved stent implantation compared to standard imaging?
Does the use of rapid prototyping models improve cardiologist confidence in planning percutaneous pulmonary valved stent implantation compared to standard imaging?
Rapid prototyping models (3D printing) of patient anatomy can significantly improve cardiologist confidence in planning percutaneous pulmonary valve implantations.
Answers are grounded in this paper and cite their sources.
May boost cardiologist confidence in pulmonary valved stent planning; leaves open effects on outcomes and requires prospective validation.
Percutaneous replacement of the pulmonary valve is a recently developed interventional technique which involves the implantation of a valved stent in the pulmonary trunk. It relies upon careful consideration of patient anatomy for both stent design and detailed procedure planning. Medical imaging data in the form of two-dimensional scans and three-dimensional interactive graphics offer only limited support for these tasks. The paper reports the results of an experimental investigation on the use of arterial models built by rapid prototyping techniques. An analysis of clinical needs has helped to specify proper requirements for such model properties as cost, strength, accuracy, elastic compliance, and optical transparency. Two different process chains, based on the fused deposition modelling technique and on the vacuum casting of thermoset resins in rubber moulds, have been tested for prototype fabrication. The use of anatomical models has allowed the cardiologist's confidence in patient selection, prosthesis fabrication, and final implantation to be significantly improved.
No takes yet. Share an insight, caveat, or question.
Armillotta et al. (2007) studied Percutaneous replacement of the pulmonary valve. Rapid prototyping anatomical models was evaluated on Cardiologist's confidence in patient selection, prosthesis fabrication, and final implantation. The use of rapid prototyping anatomical models significantly improved the cardiologist's confidence in patient selection, prosthesis fabrication, and final implantation for pulmonary valved stents.
Synapse has enriched 10 related papers. Consider them for comparative context: