Answers are grounded in this paper and cite their sources.
• ABS–Cu/Sn composites can be electroplated after laser surface treatment. • UV laser ablation exposes Cu fibres and Sn; IR radiation solders fillers, forming a conductive surface. • The composite with highest Sn content showed the most extensive metallisation. • Laser-induced conductive surfaces were successfully electroplated. • Further optimisation of irradiation is anticipated to improve metallisation. This study presents a novel approach to the direct metallisation of polymer composites. The investigated composites were based on an acrylonitrile–butadiene–styrene (ABS) matrix and incorporated conductive fillers consisting of various ratio of copper fibres to tin powder, with a total filler content of 25 vol%. Ultraviolet (UV) laser irradiation (λ = 343 nm) selectively ablated the polymer matrix and exposed the embedded conductive fillers. Subsequent infrared (IR) laser irradiation (λ = 1030 nm) partially melted the tin and promoted its bonding with the copper fibres. This sequence produced an electrically conductive surface layer. The modified surfaces were subsequently subjected to electroplating, which effectively resulted in copper coatings. Changes in surface geometry and chemical structure arising from the sequential laser treatment (UV followed by IR) were characterised. In addition, the adhesion strength of the deposited metallic coatings was evaluated.
No takes yet. Share an insight, caveat, or question.
Rytlewski et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: