Answers are grounded in this paper and cite their sources.
In this study, Zn–W films were developed on 316L stainless steel via chronopotentiometric electrodeposition to improve its protective performance. Zinc was employed for its ability to form a passive layer, while tungsten was incorporated to enhance mechanical strength and durability. A citrate-based electrolyte was used to facilitate co-deposition, overcoming the challenges of direct tungsten electrodeposition. Deposition was conducted within a current density range of −35 to −50 mA cm−2, as identified from cyclic voltammetry. X-ray diffraction confirmed the formation of hcp Zn–W phase with crystallite sizes of 15–22 nm, indicating microstructural refinement due to tungsten incorporation. The resulting films exhibited a smooth, compact and flower-like morphology. Energy-dispersive spectroscopy (EDS) analysis indicated that the coatings were predominantly Zn-rich, with a maximum Zn content of ∼97.62 wt.% obtained at −35 mA cm−2. At higher current densities, the Zn content decreased slightly, while the maximum tungsten incorporation reached ∼3.28 wt.%. The coatings exhibited an average thickness of ∼ 1.5 µm, confirming the formation of a uniform and continuous layer over the substrate. Open-circuit potential measurements indicated passive layer formation. Tafel analysis showed the highest polarisation resistance (Rp) of 223 Ω cm² at −35 mA cm−2.
No takes yet. Share an insight, caveat, or question.
Singh et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: