Answers are grounded in this paper and cite their sources.
The efficiency of the Fenton process applied to treat wine distillery wastewaters (WDWs) was assessed. Strategies considered were: i) the Fenton oxidation of an untreated (raw) effluent to enhance its biodegradability for subsequent biological digestion (Strategy 1); and ii) the Fenton oxidation of an aerobically treated WDW with the main goal of generating a wastewater which meets the standards imposed by the EU regulation for water reuse (Strategy 2). For both strategies, a parametric study was performed to evaluate the effects of initial pH (3.0 to 8.2), oxidant addition method (single or spaced addition), oxidant concentration (4 to 34 g/L for Strategy 1, and 0.23 to 1.35 g/L for Strategy 2), catalyst concentration (0.34 to 1.70 g/L for Strategy 1, and 8 to 120 mg/L for Strategy 2) and temperature (25 to 60 °C) on phenolic and organic matter removal. A synthetic WDW was used for Strategy 1, while a previously biodigested real effluent was employed for Strategy 2, due to a lack of compositional data for aerobically treated WDW. For Strategy 1, with the best conditions found (25 g/L hydrogen peroxide, pH of 4.0, temperature of 35 °C, 0.85 g/L of iron and 2 h of oxidation), the Fenton's process reduced the effluent's chemical oxygen demand (COD) by 50 % and its total phenolic content (TPh) by 98 %. An increase in the biochemical-to-chemical oxygen demand ratio (BOD 5 :COD) from 0.04 to 0.60 was also observed. The high dose of hydrogen peroxide needed for this type of effluent, however, would be economically hindering. For Strategy 2, an analogously optimized 2-h Fenton's oxidation with a 25-fold lower hydrogen peroxide concentration (0.9 g/L) and a pH of 3.0, a temperature of 45 °C and iron concentration of 0.09 g/L, was able to remove 46 % of the effluent's COD. All mandatory legislation limits (BOD 5 ≤ 5 mg/L, total suspended solids (TSS) ≤ 10 mg/L, turbidity ≤5 NTU and E. coli contamination ≤10 CFU/L) fell within their required limits. A desirable smaller temperature increase was also observed. The best operating conditions were then used in a pilot-plant sized reactor (30 L ), which presented similar performance levels to the laboratory run and a COD reduction of 49 %. These findings highlight the homogeneous Fenton oxidation as a promising technique for industrial applications.
No takes yet. Share an insight, caveat, or question.
Lemos et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: