Answers are grounded in this paper and cite their sources.
A next generation material for surface passivation of crystalline Si is Al 2 O 3 . It has been shown that both thermal and plasma‐assisted (PA) atomic layer deposition (ALD) Al 2 O 3 provide an adequate level of surface passivation for both p‐ and n‐type Si substrates. However, conventional time‐resolved ALD is limited by its low deposition rate. Therefore, an experimental high‐deposition‐rate prototype ALD reactor based on the spatially separated ALD principle has been developed and Al 2 O 3 deposition rates up to 1.2 nm/s have been demonstrated. In this work, the passivation quality and uniformity of the experimental spatially separated ALD Al 2 O 3 films are evaluated and compared to conventional temporal ALD Al 2 O 3 , by use of quasi‐steady‐state photo‐conductance (QSSPC) and carrier density imaging (CDI). It is shown that spatially separated Al 2 O 3 films of increasing thickness provide an increasing surface passivation level. Moreover, on p‐type CZ Si, 10 and 30 nm spatial ALD Al 2 O 3 layers can achieve the same level of surface passivation as equivalent temporal ALD Al 2 O 3 layers. In contrast, on n‐type FZ Si, spatially separated ALD Al 2 O 3 samples generally do not reach the same optimal passivation quality as equivalent conventional temporal ALD Al 2 O 3 samples. Nevertheless, after “firing”, 30 nm of spatially separated ALD Al 2 O 3 on 250 µm thick n‐type (2.4 Ω cm) FZ Si wafers can lead to effective surface recombination velocities as low as 2.9 cm/s, compared to 1.9 cm/s in the case of 30 nm of temporal ALD Al 2 O 3 .
No takes yet. Share an insight, caveat, or question.
Vermang et al. (2011) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: