Answers are grounded in this paper and cite their sources.
For measurement of nano-voltages it is required to evaluate the noise which comes from a Zener diode and a lithium battery which will be used here.This paper discusses the problems which arise when a commercial digital multimeter (D.M.M.) which has nominally resolution of 10nV is used for some measurement. That is, the magnetic fields in a usual test room which is 10-9 to 10-7 T with 60Hz and also the magnetic field which is 10-7 T and comes from the power supply part of the D.M.M. through the transformer will disturb nano-volt measurement. These magnetic fields possibly induce a 10nV in the measurement circuit of the D.M.M. This fact recommends the magnetic shielding of the measurement circuit. Moreover the D.M.M. shows 10∼20μV when the input terminals are short circuited. This fact is very a serious problem for measurement of nano-volt. We observed that linearity is not hold lower than 800nV using a single frequency sinusoidal voltage input.In order to resolve the problems mentioned above, a measured voltage is pre-amplified by a low-noise amplifier with magnetic shielding before it is input to the D.M.M. As a result, the lowest linearity improved from 800nV to 10nV is obtained.
No takes yet. Share an insight, caveat, or question.
Azuma et al. (1998) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: